Operating Instructions - Black & Decker PSL12 Instruction Manual

TO INSTALL BATTERY PACk: Insert battery pack into tool, until an audible click is
heard as shown in figure B.
TO REMOVE BATTERY PACk: Depress
the battery release buttons as shown in
figure C and pull battery pack out of tool.
SAVE THESE INSTRUCTIONS FOR FUTURE USE

OPERATING INSTRUCTIONS

WARNING:
Always wear proper eye, respiratory and hearing protection while
operating this tool.
• Use clamps or another practical way
to secure and support the workpiece
to a stable platform. Holding the work
by hand or against your body leaves it
unstable and may lead to loss of control.
• Place shoe firmly against work to be cut.
• Hold the tool with one hand as shown in
figure D. Switch on saw motor and allow it
to obtain maximum speed before applying
pressure.
TRIGGER SWITCH (FIGURE E)
The tool is equipped with a switch lock-off
feature to prevent unintentional operation.
• To switch the tool on, press the lock off
button (4) as shown in figure E, then
squeeze the on/off switch (3).
• Once the tool is on, release the lock off
button.
• Releasing the trigger turns the motor OFF.
NOTE: This tool has no provision to lock
the switch in the ON position, and should never be locked in the ON position by any
other means.
B
C
D
E
9
4
3