GE DBVH510 Owner's Manual page 9

About cycle options.
NOTE: Not all features are available on all dryer models.
E
XTEND
T
UMBLE
D
AMP
A
LERT
Extend Tumble
Minimizes wrinkles by adding
approximately 60 minutes of no-heat
tumbling after clothes are dry. The beeper
will sound every 2 minutes to remind you
to remove the clothes. The ESTIMATED
TIME REMAINING display will show 00.
Damp Alert
(on some models)
This option causes the dryer to beep when
clothes have dried to a damp level. Remove
items that you wish to hang dry. The DAMP
ALERT will only beep when this option
is selected.
Signal
Alerts you that the cycle is complete. The
beeper will continue to sound every two
minutes for the next 6 minutes, until the
clothes have been removed. The clothes
should be removed when the beeper goes
off so wrinkles don't set in.
Delay Start
Use to delay the start of your dryer.
1. Choose your dry cycle and any options.
2. Press DELAY START. You can change the
delay time in 1 hour increments using
the + or – arrow pads.
3. Press the START pad to start the
countdown.
The countdown time will be shown in the
ESTIMATED TIME REMAINING display.
Removing clothes and hanging them when
they are damp can reduce the need to iron
some items.
Press SIGNAL to select low, medium or high
volume, or to turn the beeper off.
NOTES:
I If the door is opened while the dryer is
in DELAY, the countdown time will not restart
unless the door is closed and START has been
pressed again.
I You can delay the start of a dry cycle up to
18 hours for models DCVH515, DHDVH52,
DBVH512, DCVH660, DHDVH66 and up to
10 hours for model DBVH510.
ge.com
9