GE DBLR453ET Owner's Manual page 16

Problem
16
Possible Causes
No fabric softener was used
Synthetics, permanent press
and blends can cause stitic
Large loads of heavy items
Lint fiiter is f~
Blown fuses or tripped
circuit bre&ers
combining loads
What to Do
Adjust controls for less drying.
Separate heavy items from lightweight items
(generally, a well-sorted washer load is a
well-sorted dryer load).
Large, heavy loads contain more moisture
and take longer to dry. Separate large, heavy
items into smaller loads to speed drying time.
Match control settings to the load you
are drying.
Clean lint filter before every load.
Check installation instructions for proper
Make sure ducting is clean, free of kinks
and unobstructed.
. Check to see if outside wall damper
operates easily.
. See the Venting the Dryer section.
Replace fuses or reset circuit breakers. Since
most dryers use 2 fuses/breakers, make sure
both are operating.
Do not put more than one washer load in
the dryer at a time.
If you are drying only one or two items,
add a few items to ensure proper tumbling.