GE 71722 Owner's Manual page 14

How to Use the Carpet Shampooer/Extractor
for Upholstery and Stair Cleaning
Solution
Release
Trigger
NOTE: If the cleaning solution and water are not released from the upholstery/stair nozzle, there may be an air
lock. With unit in the Off position, raise the attachment handle above your head. Then engage the
attachment handle trigger for 4 seconds. Turn unit On to resume spraying.
NOTE: If you should encounter a clog in the Upholstery/Stair Nozzle Filter:
1) Remove the "M" shaped piece on the underside
of the Upholstery/Stair Nozzle (Use a small
screwdriver to pry loose).
2) Clear and rinse any debris from the "M" shaped
piece by placing it under running water.
3) Replace the "M" shaped piece into the solution
tube then position and lock the piece into place.
14
C. Place the Upholstery Nozzle at the top of the cleaning
area.
D. Pull up and hold the solution release trigger and pull
the nozzle backward at a moderate pace.
E. Release the trigger at the end of the stroke.
F. Lift nozzle and start again at the top. Apply one to three
spraying strokes. Avoid over-soaking the area.
NOTE:
As the nozzle moves over the surface, the cleaning
solution sprays onto the surface. At the same time
the nozzle picks up the dirty water and places it in
the recovery tank.
G. Move the nozzle over the surface several more times
without engaging the trigger. This removes excess water
and helps the surface dry faster.
H. Brush roll does not rotate when cleaning in the
attachment mode.
Solution Tube
Trigger
(continued)
"M" Shaped Piece