Download Print this page
NAPCO GEM-RECV16 Installation Instructions
NAPCO GEM-RECV16 Installation Instructions

NAPCO GEM-RECV16 Installation Instructions

Gem-recv series

Advertisement

Quick Links

333 Bayview Avenue
Amityville, New York 11701
For Sales and Repairs, (800) 645-9445
For Technical Service, (800) 645-9440
Publicly traded on NASDAQ
Symbol: NSSC
© NAPCO 2006
DESCRIPTION
GEM-RECV Series receivers are the hardwired interface to
Napco's Wireless-Ready
tem comprises a compatible GEM-Series control panel, at least
one GEM-RECV receiver and one or more companion GEM-
Series transmitters. The transmitters may be wireless smoke
detectors, space-protection devices, window/door sensors, or
other devices that report zone status and supervision informa-
tion to the receiver without the use of wires.
THE GEM-RECV RECEIVER
Five receivers are available: GEM-RECV8, GEM-RECV16,
GEM-RECV32, GEM-RECV96, GEM-RECV255 will accommo-
date up to 8, 16, 32, 96 and 255 wireless zones, respectively.
The receiver is connected to the control panel's 4-wire bus. The
receiver monitors each transmitter, updating transmitter status
as reports are received, and conveys this information to the
control panel. Also monitored is the elapsed time since the last
report from each transmitter. If no report is received within a
programmed time, a Supervisory Failure will result.
COMPATIBLE CONTROL PANELS
The GEM-receivers listed above are compatible with the follow-
ing control panels:
GEM-P816
GEM-P3200
COMPATIBLE TRANSMITTERS
Any of the following Napco wireless transmitters may be used
with the GEM-RECV Series Receivers.
GEM-TRANS2 Window/Door Sensor - This supervised, two-
point transmitter provides an internal magnetic reed switch
and/or terminals for two external normally-closed devices,
or one external normally-open device.
GEM-PIR - Wireless PIR Motion Sensor.
GEM-PIRPET - Wireless 30lb. Pet Immune PIR Motion Sen-
sor.
GEM-DT - Dual-Technology PIR / Microwave Sensor.
GEM-SMK - Wireless Photoelectric Supervised Smoke Detector.
GEM-HEAT - Wireless Heat Detector 135°F / Rate of Rise.
GEM-KEYF - Mini Keyfob / Key Chain Remote Arming or Emer-
gency Transmitter.
GEM-WP - Wireless Waterproof Panic Button.
GEM-GB - Glass-Break Sensor.
GEM-RTRANS - Recessed Window/Door Transmitter
GEM-KEYFLR - Full-size, Long-Range Key Chain / Pendant
Remote Arming / Emergency Transmitter
R
TM
Control Panels. The wireless sys-
GEM-P1632
GEM-P1664
GEM-P9600
GEM-X255
GEM-RECV8
GEM-RECV16
GEM-RECV32
GEM-RECV96
GEM-RECV255
Wireless Receivers
SPECIFICATIONS, GEM-RECV Receiver:
Operating Temperature: ...................................... 0°C to 49°C
Storage Temperature: .....................................20°C to + 85°C
Power Requirements: ......12VDC, 70mA (supplied by panel)
Antenna: .............................................................. ¼ - wave (2)
Dimensions: ..............................6¾" x 3
NOTE: For UL Residential Installations, a maximum of 200
supervisory reporting transmitters may be installed. This
does not include GEM-KEYF or GEM-WP remotes.

ORDERING INFORMATION

Note: Batteries are included with all transmitters.
GEM-RECV8
GEM-RECV16
GEM-RECV32
GEM-RECV96
GEM-RECV255
GEM-DT
GEM-GB
GEM-KEYF
GEM-PIR
GEM-PIRPET
GEM-SMK
GEM-HEAT
GEM-TRANS2
GEM-WP
DL123A
INSTALLATION
Designing the System
In planning the layout of the system, give careful consideration
to the location of the receiver. Regardless of where the control
panel is mounted, the receiver should be centrally located
within the premises, that is, equally distant from all transmitters.
Choose a location as high above ground level as practical (attic
installations are not recommended), keeping in mind that metal
objects may adversely affect reception. Draw a layout of the
system, identifying all proposed transmitter locations and antici-
pated receiver location. Also include notations indicating con-
struction materials in use. Although wood and wallboard con-
struction will have little effect upon signal strength at the re-
ceiver, concrete or brick can reduce signal strength by up to
35%, while steel-reinforced concrete or metal lath and plaster
can reduce transmitter strength as much as 90%.
INSTALLATION INSTRUCTIONS
5
" x 1½" (W x H x D)
/
8
8 - Point Receiver/Interface
16 - Point Receiver/Interface
32 - Point Receiver/Interface
96 - Point Receiver/Interface
255 - Point Receiver/Interface
Dual-Technology PIR/Microwave sensor
Glass-Break Detector
Hand-Held Key Fob Pendant/Key chain
Panic Button
Wireless PIR Motion Sensor
Wireless 30lb. pet immune PIR Motion Sen-
sor
Supervised Smoke Detector
Wireless 135°F Heat Detector / Rate of
Rise
2-Point Window/Door Transmitter
Wireless Waterproof Panic Button
Replacement Lithium Battery for GEM-
TRANS2, GEM-RTRANS, GEM-PIR (2),
GEM-PIRPET (2) and GEM-GB (2) (bulk
packed)
WI751C 5/06
1

Advertisement

loading

Summary of Contents for NAPCO GEM-RECV16

  • Page 1: Ordering Information

    Wireless Waterproof Panic Button COMPATIBLE TRANSMITTERS DL123A Replacement Lithium Battery for GEM- Any of the following Napco wireless transmitters may be used TRANS2, GEM-RTRANS, GEM-PIR (2), with the GEM-RECV Series Receivers. GEM-PIRPET (2) and GEM-GB (2) (bulk GEM-TRANS2 Window/Door Sensor - This supervised, two-...
  • Page 2 Quick Method a report from that not yet been received. Readings less than If a receiver is already installed in the panel, Napco Trans- "3" indicate reception is poor and may be unreliable. In this mitter wireless points can be programmed automatically case, the use of a second receiver located closer to the is ad- ("enrolled").
  • Page 3: Led Indications

    visable. For installations that include several transmitters, note above). Also, check for an object in the path of the multiple receivers may be connected to the panel. (Only the transmitter blocking reception. highest signal strength will be displayed). WL TAMPER - E15-NN. Tamper condition Indicates that a transmitter case is open .
  • Page 4: Napco Limited Warranty

    NAPCO will, within said period, at its option, repair or replace any In no event shall NAPCO be liable for an amount in product failing to operate correctly without charge to the excess of NAPCO's original selling price of the product, original purchaser or user.

This manual is also suitable for:

Gem-recv32Gem-recv8Gem-recv255Gem-recv96