GE AJCM 10 Owner's Manual page 6

About the controls on the air conditioner—Heat/Cool Models
Appearance may vary.
Lights beside the touch pads on the air conditioner
Controls
ON/OFF
Turns air conditioner on and off.
Remote Control
■
To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
■
The remote control signal has a range
of up to 21 feet.
6
Air Conditioner Controls
control panel indicate the selected settings.
Display
Displays the temperature setting. Displays
hours when setting the timer.
MODE
On the air conditioner controls, use to set
COOL, HEAT or FAN mode. Indicator lights
on the air conditioner controls will show the
mode selected.
TEMP Increase + /Decrease – Pads
Use to set temperature when in COOL
or HEAT mode.
FAN Speeds
Use to set the fan speed at LOW or HIGH.
Indicator lights will show the speed selected.
Remote Control
TIMER
ON—When the air conditioner is off, it can
be set to automatically turn on in half an
hour to 24 hours at its previous setting.
Each touch will set the time in half hours
up to 10 and then in hours up to 24.
To cancel the On Timer, press the ON pad
until the display time disappears.
OFF—When the air conditioner is on, it can
be set to automatically turn off in half an
hour to 24 hours. Each touch will set the
time in half hours up to 10 and then in hours
up to 24.
To cancel the Off Timer, press the OFF pad
until the display time disappears.
Remote Control Signal Receiver
NOTE: When the air conditioner is turned on,
it will automatically start in the setting last used
■
Make sure nothing is between the air
conditioner and the remote control that could
block the signal.
■
Make sure batteries are fresh and installed
correctly—see the Care and Cleaning section.
.