Table of Contents
Advertisement
To remove the dirt:
1. – Remove immediately: melted plastic,
plastic foil, and food with sugar. If not,
the dirt can cause damage to the appli-
ance. Use a special scraper for the
glass . Put the scraper on the glass sur-
face at an acute angle and move the
blade on the surface .
– Remove after the appliance is suffi-
ciently cool: limescale rings , water
Troubleshooting
Problem
You cannot activate or operate the
appliance.
The residual heat indicator does
not come on.
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
customer service. Give the data from the rating
plate, three digit letter code for the glass ce-
ramic (it is in the corner of the glass surface)
and an error message that comes on.
Installation
Warning! Refer to the Safety chapters.
Before the installation, note down the
serial number (Ser. Nr.) from the rating
plate.The rating plate of the appliance is
on its lower casing.
ZEV6940XBV
58 PEE 15 AO
220-240 V 50-60 Hz
Made in Germany
ZANUSSI
Built-in appliances
• Only use the built-in appliances after you as-
semble the appliance into correct built-in
www.zanussi.com
2. Clean the appliance with a moist cloth and
3. At the end rub the appliance dry with a
Possible cause
The appliance is not connected to
an electrical supply or it is con-
nected incorrectly.
Problem with the house electrical
system.
The cooking zone is not hot be-
cause it operated only for a short
time.
Make sure, you operated the appliance correct-
ly. If not the servicing by a customer service
technician or dealer will not be free of charge,
also during the warranty period. The instruc-
tions about the customer service and condi-
tions of guarantee are in the guarantee booklet.
units and work surfaces that align to the
standards.
Connection cable
• Use the correct mains cable of type H05BB-
F Tmax 90°C (or higher) for a single phase or
two phase connection.
949 595 548 00
• Replace the damaged mains cable with a
special cable (type H05BB-F Tmax 90°C or
6,5 kW
higher). Speak to your local Service Centre.
rings, fat stains, shiny metallic discolora-
tions. Use a special cleaning agent for
glass ceramic or stainless steel.
some detergent.
clean cloth.
Check if the appliance is correctly
connected to the electrical supply
(refer to connection diagram).
Examine the fuse in the electrical
system of the house in the fuse
box. If the fuses blow again and
again, speak to qualified electri-
cian.
If the cooking zone operated suffi-
ciently long to be hot, speak to the
service centre.
Remedy
7
Advertisement
Table of Contents
