Description Of The Rear Cabinet - Boss Audio Systems BV7320 User Manual

In-dash dvd/mp3/cd am/fm receiver with 3.2" (81mm) widescreen tft monitor with dual (front and rear) usb ports, sd memory card port and front panel av input
Hide thumbs Also See for BV7320:
Table of Contents

Advertisement

HUE
It is for adjusting the hue of the video output.
SATURATION
It is for adjusting the saturation of the video output.
SHARPNESS
It is for adjusting the sharpness of the video output.
5.19.5 SPEAKER SETUP
SPEAKER SETUP
DOWNMIX
DOWNMIX
It is for selecting your desired sound effect when there is not central speaker
and sub-woofer. There are 3 mode: LT/RT, STEREO, VSS.
LT/RT: When playing a disc with PRO LOGIC Dolby stereo effect, choose the
item, so it will output audio signal with vivid theatre effect.
STEREO: If you choose the item, when outputting audio signal with 5.1 channels,
it will output the left and right channels of signal ; when outputting audio signal
with 2 channels, it will output the common 2 channels of stereo signal.
VSS: If you choose the item, when playing a disc recorded with 5.1 channels,
the main channel speakers can output audio signal with VSS effect.
5.l9.6 DIGITAL SETUP
DIGITAL SETUP
OP MODE
DYNAMIC RANGE
DUAL MONO
OP MODE
It is for selecting audio output mode
LINE OUT: It can linearly compress the audio signal. So the volume level is lower.
RF REMOD: It can make the volume level higher.
DYNAMIC RANGE
After selecting the compression mode of LINE OUT, set the item, so you can
adjust the linear compression ratio. If you set it to be FULL, the Peak-to-Peak
value of the audio signal is the minimum; if you set it to be OFF, the Peak-to-
Peak value is the maximum.
DUAL MONO
It is for selecting a desired audio output mode for the left and right ways of signal.
There are 4 modes in all as follows: STEREO, MONO L, MONO R, MIX MONO.
PDF created with FinePrint pdfFactory Pro trial version
Parking Line GREEN
Rear View Camera
In any running mode, the video signal will switch to camera mode (if applicable)when car is in reverse.
After taking the car out of reverse, it will resume to its previous mode.
http://www.pdffactory.com

1.7 Description of the Rear Cabinet

GREEN
GREY
SUBWOOFER
RED R
RED R
GREY
BLACK
REAR RCA LINE OUT
FRONT RCA LINE OUT
GREY
BLACK
WHITE L
WHITE L
Reversal line White
YELLOW
BLACK
GRAY
USB LINE IN
VIDEO OUT
GRAY
YELLOW
Note:1. Parking wire must be c onnected , and the park ing b rake must be engaged in order for the monitor to work
2. Use the clip e nd of the Ground wire provided by manufacturer to connect Mounting Scre w, use the oth er
end of th e Ground wire to conne ct the negative pol e of t he p ower source. Otherwise, the video on scre en
may flac hes.
Connecting the parking brake line to the parking brake system built in the car
Parking brake
Parking brake switch
(inside the car)
Analog on-site backup
Warning:
Always check the surrounding environment. Objects might be reversed. The rear view
camera is designed only to assist while reversing. Due to the limitations of the camera
angle and range, it may cause accidents if the driver relies solely on the reverse camera
and display.
Fixing Screw Bolt
Fixed ISO Female Connector
Parking brake wires(Green)
To metallic body or chassis of the car
P I C
A N G L E
Analog on-s ite backup

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

625uab

Table of Contents