Table of Contents
Advertisement
Installation
Instructions
(cont'd)
Installation Checklist
Whether
or not the element
conversion
is made, the model
rating plate must
be marked.
Using a hard point
ink pen,
check the appropriate
block within
the model
rating plate,
which is located adjacent to the lower access panel.
Is the fuse or circuit breaker size correct as shown in the chart
in the "Product
Specifications"
section?
•
Are the wires from the circuit breaker or fuse service to the
water heater's junction box on the correct wire size (gauge) as
shown m the chart in the Product
Spectficauons
section.
• Is the new temperature-pressure
relief valve properly
installed, and piped to an adequate drain? See "Temperature-
Pressure Relief Valve section.
•
Is the water heater completely
filled with water? See "Filling
the
Water
Heater"
instructions
in the
"Installation
Instructions
section.
• Will a water leak damage anything?
See "Facts to Consider
About the Location"
section.
• Are the cold and hot water lines connected
to the water heater
correctly? See "Water Piping" instructions in the "Installation
Instructions
section.
•
Is there adequate
clearance for maintenance
around
the water
heater?
•
Do you need to call your electric
company
to check your
wiring?
HOT
IF-7
COLD
TEMPERATURE-
_PRESSURE
RELIEF VALVE
--DISCHARGE
PIPE
(Do not cap or plug)
6 " AIR GAP
FLOOR DRAIN
MODEL RATING
PLATE
15
Advertisement
Table of Contents
