Summary of Contents for AOR SDU-5000
- Page 28 The receiver must be configured and switched On before the SDU5000 in order to guarantee a valid connection via the RS232. Note: The output level of the ICOM receiver(s) is about 10 - 15dB below that of the AOR receiver(s). Should the connection be lost, use “CONF” to confirm that the correct receiver had been selected.
- Page 29 Of course you can work the formulae backwards too! If you require a 5kHz step: 5 x 16 x 10 = 800 kHz - you may note a quick way: simply divide or multiply by 160 (the total number of increments) The following relative table may be of assistance: Each marker movement Bandwidth (span)