Connecting A Powerline Av+ 500 Adapter To The Router - NETGEAR XAVB5501 User Manual

Powerline av+ 500 adapter
Hide thumbs Also See for XAVB5501:
Table of Contents

Advertisement

Connecting a Powerline AV+ 500 Adapter to the Router

1.
Plug an XAV5501 into a power outlet near your router.
Use the supplied gray Ethernet cable to connect from the XAV5501 to a LAN port on your
router so that the Powerline network can gain access to the Internet. The Power and
Ethernet LEDs on the Powerline XAV5501 Adapter should turn on.
Note:
It is not necessary to disconnect your router from your computer.
Router
Figure 3. Connecting the XAV5501 to a Router
2.
Once the Powerline adapter is plugged in and power is first applied, check to see that the
Power LED is on.
3.
After approximately 10 seconds, check to see that:
a. The Power LED is solid green.
b. The Powerline LED is lit.
c. The Ethernet LED is on or blinks.
8 |
Chapter 1. Installation and Basic Configuration
XAV5501 Powerline AV+ 500 Adapter User Manual
Supplied Ethernet cable
XAV5501 Powerline
AV+ 500 Adapter
Laptop PC
Desktop PC

Advertisement

Table of Contents
loading

Table of Contents