Onboard Headers And Connectors - ASROCK H61M-DG4 User Manual

2.8 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA2 Connectors
(SATA_0: see p.13, No. 9)
(SATA_1: see p.13, No. 8)
(SATA_2: see p.13, No. 11)
(SATA_3: see p.13, No. 10)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB4_5)
(see p.13 No. 12)
(9-pin USB6_7)
(see p.13 No. 14)
Infrared Module Header
(5-pin IR1)
(see p.13 No. 15)
SATA_3 SATA_1
SATA_2 SATA_1
22
These four Serial ATA2
(SATA2) connectors support
SATA data cables for internal
storage devices. The current
SATA2 interface allows up to
3.0 Gb/s data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATA2 hard disk or the
SATA2 connector on this
motherboard.
Besides four default USB 2.0
ports on the I/O panel, there
are two USB 2.0 headers on
this motherboard. Each
USB 2.0 header can support
two USB 2.0 ports.
This header supports an
optional wireless transmitting
and receiving infrared module.