Garrett Graphic Target Profiling 1350 Owner's Manual page 39

4. Slide out the two battery holders (which are
not connected by the wire) by tilting the pack.
Each of the holders contains four AA
batteries.
5. Remove the old batteries.
6. Install new batteries. Carefully observe the
polarity of the batteries and place them in the
holders.
7. Replace the battery holders in the GTP 1350.
Ensure the rivet on each side of the battery
holder is visible in the center of the battery
case. If the holders are replaced incorrectly, it
will be difficult to install the battery covers.
8. Press down and firmly slide each battery
cover into place.
CAUTION!
Use high quality rechargeable (NiCad, NiMH),
carbon, alkaline or heavy duty batteries.
Graphic Target Profiling 1350
™
3