Creating A Number Table From A Function (Table) - Casio fx-92B User Manual

Note: • Even if Natural Display is selected, the solutions of simultaneous
linear equations are not displayed using any form that includes
cannot be converted to engineering notation on the solution screen.
Changing the Current Equation Type Setting
Press (EQN) and then select an equation type from the menu that
appears. Changing the equation type causes the values of all Coefficient
Editor coefficients to change to zero.
EQN Mode Calculation Examples
x y
+ 2 = 3, 2
(EQN)
x y z
– +
(EQN)
Creating a Number Table from a
Function (TABLE)
TABLE generates a number table for
function.
Perform the following steps to generate a number table.
1. Press
2. Input a function in the format
• Be sure to input the X variable (
Any variable other than X is handled as a constant.
• Pol and Rec cannot be input in the function.
3. In response to the prompts that appear, input the values you want to use,
pressing
For this prompt: Input this:
Start?
End?
x y
+ 3 = 4
(a X + b
n
x y z
= 2, + – = 0, –
(a X + b
n
1
1
1
(TABLE) to enter the TABLE Mode.
after each one.
Input the lower limit of X (Default = 1).
Input the upper limit of X (Default = 5).
Note: Make sure that the End value is always
greater than the Start value.
Y = c )
n n
1 2 3
2 3 4
x y z
+ + = 4
Y + c Z = d )
n n n
1 1 2
1 1 0
1 1 4
x
f x
( ), using the X variable.
) when generating a number table.
E-20
f x
and ( ) using an input
. • Values
Math Math
(X=) –1
(Y=) 2
Math Math
(X=) 1
(Y=) 2
(Z=) 3
f x
( )