Panasonic WV-NF284 Installation Manual page 21

Connections
Step 1
Connect the monitor cable (provided as a
standard accessory) between the monitor out
connector inside the dome cover and the
video in connector of the video monitor (only
when adjusting angular field of view).
Monitor out connector (for adjustment)
Important:
The monitor out connector is provided
only for checking the adjustment of the
angular field of view on the video monitor
when installing the camera or when serv-
icing.
It is not provided for recording/ monitor-
ing use.
Step 2
Connect a power cord from a power supply.
Power cord terminals
D O
M E
IN S C O
E R
V E
T
R
A D
J U
S T
L O
C K
N
• When using AC 24 V/DC 12 V power sup-
ply
q Remove 3 mm – 7 mm of the outer jacket
of the power cord from a DC 12 V or an
AC 24 V power supply and twist the core
of the power cord to prevent a short cir-
cuit.
Approx. 3 mm - 7 mm
Specification of cable (wire):
AWG #16 - #28 Single core, twisted
w Loosen the screws of the provided power
cord plug and insert the power cords into
the power cord plug until the exposed
core wires are completely hidden.
e Tighten the screws to fix the inserted
power cords.
* Make sure that the exposed core wires
are completely hidden after tightening
the screws.
<24 V AC>
1L 2N
GND
24 V AC IN
A 2 N
B GND
C 1 L
r Insert the power cord plug to the power
cord terminals on the mounting side of
the camera.
* Make sure that the power cord plug is
inserted to the power cord terminal firm-
ly.
<12 V DC>
! @
Power cord plug
(provided as a
standard accessory)
12 V DC IN
@
NC
!
21