Vox Lil Looper Owner's Manual page 23

3.
Adjust the volume of Loop 1 with the LOOP
LEVEL/VALUE knob.
The volume balance of the loop and instrument
will be adjusted.
4.
At the point where you want to start overdubbing,
press the LOOP1 pedal, and play your instrument.
The Loop 1 REC status LED will light-up red, and
overdubbing will begin.
5.
Press the LOOP1 pedal at the point where you
want to stop overdubbing.
The Lil' Looper will switch from overdubbing to
loop playback.
6.
Press the LOOP1 pedal twice to stop Loop 1
playback.
Overdubbing undo and redo functions
If a loop is stopped, the undo and redo information
will be deleted.
Undo function
Execute this function when you want to delete the
contents that were overdubbed last.
1.
Hold down the LOOP pedal during playback or
overdubbing.
2.
Release the pedal when the PLAY status LED
blinks orange.
The undo function will be executed.
If new overdubbing is performed over the recording
that was just undone, the previous content will be
deleted.
Redo function
The Undo function will be cancelled, and the previous
status will be restored.
1.
From the procedure that was undone, hold down
the LOOP pedal.
2.
Release the pedal when the PLAY status LED
blinks green.
The redo function is executed.
Creating phrases
23