Epson B-510DN Quick Start

Start Here
B-310N/B-510DN
Before using the printer, make sure you read the safety instructions in the
User's Guide on your printer CD.
1
Unpack
If anything is missing, contact Epson as described on the back of this sheet.
The following instructions apply to both the B-310N and B-510DN, unless
otherwise noted.
Note: The appearance of your printer may differ from what you see here,
depending on your model and accessories installed.
Remove all the tape and other packing material, including tape on the
duplexer at the back of the printer. Insert the paper cassette into the printer.
2

Turn on the printer

1
Connect the power cable.
Note: Do not connect to the computer at this time.
2
Press the button.
*411826000*
*411826000*
3
Install cartridges
1
Open the cartridge cover.
2
Unpack the 4 ink cartridges.
3
Shake each cartridge for about 5 seconds.
4
Make sure the cartridge lever is all the way up, then install each
cartridge in the correct slot for its color.
The arrow mark should be on top and pointing toward the printer.
Push each cartridge in until it clicks.
5
After you install all 4 cartridges, lower the cartridge lever to the
locked position.
6
Close the cartridge cover.
The printer starts charging the ink. This takes about 5 minutes.
Caution: Don't turn off the printer or open any covers while it is
charging or you'll waste ink.
Note: The printer ships with full cartridges and part of the ink from
this first set of cartridges is used for charging the printer.
Cartridge lever