Table of Contents
Advertisement
I_l
Select the position that will place the sill supports
near the outermost point on sill (FIG. 10).
Attach the sill supports to the cabinet track hole
closest to the selected position using screw (ITEM E).
Cabinet
I_l
Place the sill supports with the cabinet on the
window sill's selected position.
t'[i]
The cabinet should be installed with a very
slight tilt (about 1/4") downward toward the outside
(FIG. 11).
Adjust the bolts and the nuts of sill supports to level
the cabinet.
M8
FIG. 11
_1
Attach the cabinet to the inner sill by driving the
screws (ITEM F) through the front angle into the
window inner sill (FIG. 12).
Track
ITEM B
ITEM F
FIG. 12
'[_J Attach the L BRACKET (ITEM J) with screw
ITEM G). (FIG. 14)
_ITEM G
FIG. 14
i_l
DRAINAGE
Be sure to insert the drain pipe into base pan before
installation.
The air conditioner must be installed with a slight tilt
to the outside for proper water drainage.
The air conditioner will drain the excess condensed
water through the drain pipe. (FIG. 15)
]_J.,--- B ASEPANREAR
DRAIN_
FIG. 15
B
Slide the chassis into the cabinet. (FIG. 16)
CAUTION: For security purposes, reinstall side
screws you removed in step 1.
Sc_ew
__Screw
_'c°rd
FIG 16
B
Cut the foam seal (ITEM H) to the proper length
and insert between the upper window sash and the
lower window sash. (FIG. 17)
I_
Pull each side curtain fully to each side of
window opening.
Attach each side curtain to the window sash using
screws (ITEM G). (FIG. 13)
before the decorative front is attached.
FIG. 17
li_ The ventcontrolhandle must be straightened
FIG. 18
/
-7-
Advertisement
Table of Contents
