Format 2 - Reading The Receiver's Signal Strength; Format 3 - Transmitting The Memory Contents; Change The Receive Modes Or Make New Entries - AOR The New Classic AR3030 Operating Manual

S or
N or
X

7-7 FORMAT 2 - Reading the receiver's signal strength

Contents of transmission === nn [CR] [LF]
Contents of TX Details
n - Send the S-Meter Readings in

7-8 FORMAT 3 - Transmitting the memory contents

Contents of transmission =
Mnn Pn Rn Gn Bn Tn Fnnnnnnnn C [CR] [LF]
Note: Mnn represents HEADER and Memory channel number.
Pn indicates Memory channel Pass position:
n == 0 ... PASS-OFF
Details of each TX is same as FORMAT 1
When the selected channel is blank:
. M— [CR] [LF] ... CHANNEL # == "—"
7-9 Change the receiving modes or Make new entries
CMD Function
nn W [CR] - Write the present contents into a selected
channel and go to the memory mode.
W [CR] - Search for a blank channel and write the present
memory contents (If no blank channel is found go to the
dial mode followed by [M—]).
0 R [CR] - Selection of ATT
1 R [CR]
2 R [CR]
0 G [CR] - Selection of AGC
1 G [CR]
S
N
X
64 steps 00 ~ 3F
00
01
02
:
3E
3F
== 1 ... PASS-O N
AR3030 operating manual
S.AM
F M
FAX
MIN
MAX
OFF
10 dB
20 dB
SLOW
FAST
43