Switch Renumber - Cisco Catalyst 2960-XR Reference

switch renumber

switch renumber

To change the stack member number, use the switch renumber command in global configuration mode on
the stack master.
switch current-stack-member-number renumber new-stack-member-number
Syntax Description
current-stack-member-number
new-stack-member-number
Command Default
The default stack member number is 1.
Command Modes
Global configuration
Command History
Release
Cisco IOS 15.0(2)EX1
Usage Guidelines
If another stack member is already using the member number that you just specified, the stack master assigns
the lowest available number when you reload the stack member.
Note If you change the number of a stack member, and no configuration is associated with the new stack member
number, that stack member loses its current configuration and resets to its default configuration.
Do not use the switch current-stack-member-number renumber new-stack-member-number command on a
provisioned switch. If you do, the command is rejected.
Use the reload slot current stack member number privileged EXEC command to reload the stack member
and to apply this configuration change.
Examples This example shows how to change the member number of stack member 6 to 7:
Switch(config)# switch 6 renumber 7
WARNING:Changing the switch number may result in a configuration change for that switch.
The interface configuration associated with the old switch number will remain as a provisioned
configuration.
Do you want to continue?[confirm]
Catalyst 2960-XR Switch Stack Manager Command Reference, Cisco IOS Release 15.0(2)EX1
40
Current stack member number. The range is 1 to 8.
New stack member number for the stack member. The range
is 1 to 8.
Modification
This command was introduced.
Stack Manager Commands
OL-29435-01