Installing Hardware; Installing Memory Modules - ECS HDC-I2 Manual

10

Installing Hardware

Installing Memory Modules

This motherboard accommodates two memory module. It can support two 240-pin
DDR3 1066/800. The total memory capacity is 8 GB.
DDR3 SDRAM memory module table
You must install at least one module in any of the two slots. Total memory capacity
is 8 GB.
Installation Procedure
Refer to the following to install the memory modules.
1 This motherboard supports unbuffered DDR3 SDRAM.
2 Push the latches on each side of the DIMM slot down.
3 Align the memory module with the slot. The DIMM slots are keyed with
notches and the DIMMs are keyed with cutouts so that they can only be
installed correctly.
4 Check that the cutouts on the DIMM module edge connector match the
notches in the DIMM slot.
5 Install the DIMM module into the slot and press it firmly down until it
seats correctly. The slot latches are levered upwards and latch on to
the edges of the DIMM.
6 Install any remaining DIMM modules.
Memory module
DDR3 800
DDR3 1066
Do not remove any memory module from its antistatic packaging
until you are ready to install it on the motherboard. Handle the
modules only by their edges. Do not touch the components or metal
parts. Always wear a grounding strap when you handle the modules.
Installing the Motherboard
Memory Bus
400 MHz
533 MHz
* For reference only