Daikin FTQ18PBVJU Installation Manual page 12

(1) Remove the front panel (upper).
Top panel
Low-voltage
hole
(2) Remove the electric component box cover.
Terminal block
(3) Pass the power supply wiring and the ground wire
through the top panel's high-voltage hole (requires use of
conduit) and pass the remote controller wiring and trans-
mission wiring through the top panel's low-voltage hole.
• Pass the included insulation tube through the hole in the
panel before connecting the electric wires and the
ground wire to the terminal block shown in Fig. 8.
• Pass the included insulation tube through the hole in the
panel before connecting the remote controller wiring
and transmission wires to the terminal block shown in
Fig. 8.
• Then secure them in place with the included Clamp
material (1) as shown in Fig. 8 to protect them from
external force from outside the unit.
• If the power supply voltage is 208V, change the trans-
former wire connection from the 240V terminal to the
208V terminal. (Refer to Fig. 9)
11
High-voltage
hole
Terminal block
Transformer
<FTQ18,24,30,36PBVJU models>
Transformer
<FTQ42PBVJU model>
Changing the transformer wire connection
Connector
(Connect the wire to the 208V terminal.
Be sure to insert the wire securely until
a clicking sound is produced.)
Wire (Red)
Connector
Cap
230V power supply (factory set)
Terminal block
Terminal block
Fig. 8
Cap
(Change the
connection.)
Wire
(Red)
208V power suppy
Fig. 9
English