A Mounting Plate; B Mounting Plate Fixing Screw 3/16" × 1" (M4 × 25Mm); C Titanium Apatite Photocatalytic; D Wireless Remote Controller - Daikin FTXS09LVJU Installation Manual

Indoor Unit Installation Drawings

A Mounting plate

B Mounting plate fixing screw
3/16" × 1" (M4 × 25mm)
Front panel
1-15/16" (50mm)
or more from walls
(on both sides)
Air filters
C Titanium apatite photocatalytic
air purifying filter (2 pcs)
Titanium apatite
photocatalytic
air-purifying filter
Filter frame
Tab
Air filter
INTELLIGENT EYE sensor
CAUTION
• Do not hit or forcefully push the INTELLIGENT EYE sensor. This can lead to damage and malfunction.
• Do not place large objects near the sensor. Also keep heating units or humidifiers outside the sensor's detection area.
■
English
How to attach the indoor unit
Hook the claws of the bottom frame
to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
release the claws. If it is difficult to
release, remove the front grille.
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
1-3/16" (30mm)
or more from ceiling
INTELLIGENT EYE
sensor
3/16" × 5/8"
(M4 × 16mm)
Service lid
Opening service lid
Service lid is opening/closing type.
Opening method
1) Remove the service lid screw.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
Front grille
Caulk
pipe hole
gap
with putty.
D
Wireless
remote
controller
F Fixing screw for remote
controller holder
1/8" × 13/16" (M3 × 20mm)
A Mounting
plate
Clip
Bottom
Mark (rear side)
frame
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that no
gap is left in the insulation
pipe's cut line.
Wrap the thermal insulation
pipe with the finishing tape
from bottom to top.
Before screwing the remote
controller holder to the wall,
make sure that control
signals are properly
received by indoor unit.
E
Remote
controller holder
3