Oster Top Chop 4-Cup Food Processor User Manual page 3

LEARNING ABOUT YOUR
TOP CHOP™ 4-CUP CHOPPER
a
c
a
Pulse Button
b
Motor
c
Cover
3 www.oster.com
FPSTMC1250 4 Cup Chopper_12ESM1.indd 3-4
b
d
e
d Chopping Blade
e
Bowl
HOW TO:
Assembling the Unit
1 Remove all packaging materials before using.
2 Before using, wash cover, bowl and blade in warm soapy water;
rinse and dry thoroughly, see CARE AND CLEANING.
3 Place bowl on a flat surface and slide the chopping blade over
the metal shaft at the bottom of the bowl.
4 Place the cover on top of the bowl, so that the upper stem of
the chopping blade comes through the hole in the cover.
5 Place the red motor on top of the cover, rotating if necessary
to drop into place. The motor will "float" in the opening of the
cover, so that it can be pressed down further to activate the
chopping blade.
Chopping
1 Cut food into approximately 1.5 cm
(1/2 inch) pieces and place up to 4
cups of dry food in the bowl at a time.
2 Place the cover and motor on top of
the bowl.
3 Plug the cord into an outlet. Press and
hold the black Pulse button on top of
the motor to activate the chopping
blade. Press and hold for continuous
chopping; press and release for quick
pulse chopping. Repeat for finer
consistency. The motor and chopping
blade will stop running when you stop pressing the button.
NOTE: To avoid liquefying the ingredients, do not over chop
them. Use short presses to pulse until desired consistency is
achieved.
4 When finished chopping, allow chopping blade to stop
rotating before removing contents.
www.oster.com 4
5/17/12 8:14 AM