TIMER Operation
ATTENTION
In the following cases, set the timer again.
•
After a breaker has turned OFF.
•
After a power failure.
•
After replacing batteries in the remote controller.
20
To use ON TIMER operation
•
Check that the clock is correct.
If not, set the clock to the present time.
1.
Press
"
" is displayed.
"
" blinks.
2.
Press
until the time setting reaches the point
you like.
•
Every pressing of either button increases or decreases the time setting by 10 minutes. Holding
down either button changes the setting rapidly.
3.
Press
•
The TIMER lamp lights up.
ON
OFF
Control panel
To cancel ON TIMER Operation
Press
•
The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
•
A sample setting for combining the two timers is shown below.
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
Combined
ON TIMER at 14:00
Page 9
.
again.
.