Message Display - Panasonic Lumix DMC-SZ5 Operating Instructions Manual

Message Display

Confirmation messages or error messages will be displayed on the screen in some
cases.
The major messages are described below as examples.
[Some pictures cannot be deleted]/[This picture cannot be deleted]
•
Pictures not based on the DCF standard cannot be deleted.
> Format the card after saving necessary data on a PC etc.
[Built-in memory full]/[Memory card full]/[Not enough space on built-in memory]/
[Not enough memory on the card]
•
There is no space left on the built-in memory or the card.
•
When you copy pictures from the built-in memory to the card (batch copy), the pictures are
copied until the capacity of the card becomes full.
[Memory card error.
This card cannot be used in this camera.
Format this card?]
•
It is a format that cannot be used with this unit.
> Insert a different card and try again.
> Reformat on this unit after saving necessary data using a PC, etc. Data will be deleted.
[Please turn camera off and then on again]/[System Error]
•
This message appears when the camera is not operating properly.
> Turn the camera off and on. If the message persists, contact the dealer or your nearest
Service Centre.
[Insert SD card again]/[Try another card]
•
An error has occurred accessing the card.
> Insert the card again.
> Insert a different card.
[This battery cannot be used]
•
Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Centre.
•
If the battery terminal is dirty, clean it and remove any objects.
19
(ENG) VQT4J99