NEC MultiSync P403 User Manual page 29

DEINTERLACE Selects the IP (Interlace to Progressive) conversion function.
NOTE: For DVI input "DVI-HD" needs to be enabled in the DVI mode menu. When INPUT2 of
SUPER is selected in INPUT CHANGE and displayed, this function cannot be changed.
ON Converts interlaced signals to progressive. This is the default setting.
OFF Disables IP conversion. This setting is best suited for motion pictures, but increases the risk of
image retention.
1
COLOR SYSTEM* The selected Color System depends on the video format of the input signal.
VIDEO, S-VIDEO inputs only
AUTO
NTSC Automatically chooses Color System setting based on input signal.
PAL
SECAM
4.43 NTSC
PAL-60
OVER SCAN Some video formats may require different scanning modes in order to best display the image.
HDMI, Y/Pb/Pr, SCART* 1 , VIDEO* 1 , S-VIDEO* 1 ,
HDMI2* 1 inputs only
ON Image size is larger than what can be displayed. The image edge will appear cropped.
Approximately 95% of the image will be shown on the screen.
OFF Image size stays within the display area. The whole image is displayed on the screen.
NOTE: When you use a computer with HDMI out, please set "OFF".
OPTION SETTING You can set this setting when option board accessory is connected to the monitor.
Please contact your supplier for detailed information about Option board slot accessories.
OPTION POWER Allow the monitor to supply power to Option board slot during power save mode or standby
mode.
NOTE: This function should be set to ON when using power save management by slot 2 type
option.
AUDIO The function is available for slot 2 type option. Selects sound input signal according to slot2 type
option's specifi cations. To activate DIGITAL, select OPTION for input signal and OPTION for
AUDIO INPUT.
NOTE: DIGITAL is activated only when OPTION is selected for input signal and OPTION for
AUDIO INPUT.
INTERNAL PC The function is available for slot 2 type PC.
OFF WARNING If OPTION POWER is OFF, a warning message appears when monitor power is turned off.
NOTE: Warning message does not appear when monitor power is turned off by OFF TIMER
setting or SCHEDULE setting.
AUTO OFF Monitor power is automatically "OFF" when connected PC is OFF or the monitor is in power save
mode.
NOTE: Monitor power is not automatically "ON" when connected PC is ON.
START UP PC When ON is selected, connected PC start-up.
FORCE QUIT When ON is selected, it performs force-quit PC.
Please use this function only when the operating system cannot be shut down manually.
120Hz
(not adjustable)
TOUCH PANEL
(not adjustable)
RESET Resets the following settings within the ADVANCED OPTION menu back to factory setting:
INPUT DETECT (except the priority of input signals), INPUT CHANGE (except for INPUT1 and
INPUT2), TERMINAL SETTING, DEINTERLACE, COLOR SYSTEM, OVER SCAN, AUDIO in
OPTION SETTING.
*1: This function depends on which option board you use.
English-27
ON
AUTO
ON
-
OFF
ANALOG
OFF
OFF
NO
NO
-
-
-