Table of Contents
Advertisement
Names and Functions of Parts
Front
a Power switch / indicator
This is the power switch. The indicator lights when the
unit is turned on. Stable output of video signals may take
some time after the unit is turned on. The LINK indicator
will blink or light blue and video signals will not be
output until proper output is established.
To turn the unit off, press and hold the switch for at least
2 seconds.
b LINK indicator
Indicates the connection status.
Lit green: Connected to the partner device.
Blinking green: Connected to the partner device, but
there is a problem with the status of the network
connected to the MAIN connector.
Rear
a REF IN connector
Inputs the synchronization signal.
Input is not necessary when using the SDI signal as a
synchronization signal, or when the synchronization
setting is set to [Follower] and a frame synchronizer is not
used.
1
1
2
3
5
6
7
2
3
Blinking blue: Connection is being established. As the
connection process progresses, the indicator blinks
more rapidly.
Lit blue: Connection has been established, and the unit
is waiting for signal output to stabilize. Video
signals are not output during this time.
Off: Not connected to the LAN.
c ALARM indicator
Lights red when an error is detected.
Check the [Status] page of the web menu for details on the
error.
The indicator blinking red indicates an internal error. If
restarting the unit does not resolve the problem, consult
your Sony service representative.
4
8
9 0
b REF OUT connectors (1/2/3)
Output synchronization signals. The same signal is output
from each of these three ports.
Notes
• The subcarrier phase during black burst signal output is
not guaranteed.
• The accuracy of frequencies when synchronization is
not applied to unit is not guaranteed.
Names and Functions of Parts
9
Advertisement
Table of Contents
