Important Safety Message For Draft Beer Dispensing; Dispensing The Beer - Kenmore Haier HBF05E Installation Instructions Manual

5. Carefully tilt the beer keg and rest the edge on the stainless steel keg floor
support on the bottom of the interior cabineL Slide the beer keg in slowly,
ensuring that it is properly Iocated.(see fig. 5}
BeerKeg
Lift Upright
important ,Safety Message f@r' Dr'aft Beer' Dispensing
Hf C O2 is usedfor draft beer dispensing,the systemmustbe adequatdy protected
against excessivepressurebuild-up. This can be accomplishedby installing at least
two safety deviceswith adequate relief capacity in the system.
Safetydevicesshould be installed in the following places:
A. On or immediatelydownstreamfrom the CO2 regulaton
B_On the tapping device itself.
C_h-line in the pressuresystem.
Note: LocationsA and B noted above are preferable, Hfpossible,they should be
built into the CO2 regulator and tapping device so that the>" c annot be
removedor by-passed.
@per@tiHg Your Beer ©is_e_ser
Dispensing Beer
Follow the stepsbelow to dispensebeer.
1. Make surethat the beer dispenseris plugged in properly to a 120V, 60Hz,
15Amp grounded AC outlet.
2. Placethe drip tray under the beer faucet.
3. Open the beer faucetby pulling the tap towards you quickly and completelyto
dispensethe been
Note: If for any reasonthe beer does not come out of the tap, refer to the
trouble-shootingguide on page 17.
4. Increasethe pressureif the beer runstoo slowly. At the correct pressureand
temperature,a 10oz. glass should be filled in 4 seconds_
5. Hold the glass steadyat a 45 ° angJe_ When it is 2/3 fuji, start straighteningthe
glass. Proper foam should be a tight creamy head and the collar on an average
glass should be 3/4" to 1" high.
Note: It is normal to seecondensationforming on the outer surfaceof the faucet. It
is causedby thedifference in temperaturebetweenthe cold beer and the
inner surfacesof the faucetwhen beer is flowing through the line.
]0