Yamaha Blaster YFS200T Owner's Manual page 130

NOTE
If the cable cannot be adjusted to specification,
consult a Yamaha dealer.
4. Tighten the locknut at the clutch lever.
5. Screw in the adjusting bolt at the rear
brake caliper by hand until it feels tight,
then screw it out 1/8 turn. Tighten the lock-
nut to the specified torque.
Tightening torque:
Locknut:
16 Nm (1.6 m0kgf, 11 ft0lbf)
q
1. Adjusting bolt
cC
When tightening the locknut, hold the adjust-
ing bolt with a wrench so that the adjusting
bolt does not turn together with the locknut.
8-29
w
2. Locknut