Basic components
EMU31430
Steering friction adjuster
A friction device provides adjustable resis-
tance to the steering mechanism, and can be
set according to operator preference. An ad-
juster lever is located on the bottom of the
tiller handle bracket.
To increase resistance, turn the lever to the
port side "A".
To decrease resistance, turn the lever to the
starboard side "B".
EWM00040
WARNING
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to steer, which could result in an
accident.
B
A
If the resistance does not increase even
when the lever is turned to the port side "A",
make sure that the nut is tightened to the
specified torque.
18
1. Nut
Nut tightening torque:
3.7 Nm (2.7 ft-lb) (0.4 kgf-m)
NOTE:
Check the tiller handle for smooth move-
G
ment when the lever is turned to the star-
board side "B".
Do not apply lubricants such as grease to
G
the friction areas of the steering friction ad-
juster.
EMU26141
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, then tilts it up. Pressing
the switch "
tor down and trims it down. When the switch
is released, the outboard motor will stop in its
current position.
NOTE:
For instructions on using the power trim and
tilt switch, see pages 45 and 47.
ZMU02810
" (up) trims the
" (down) tilts the outboard mo-