Removing The Control Panel From The Car Radio; Installing The Din Assembly Bracket In The Vehicle's Instrument Panel; Connecting To The Loudspeakers Of The Vehicle - Silvercrest KH 2391 Operation Manual

1 x Stripping tongs or cable stripping knife
1 x Screwdriver
1 x SW 8 spanner (jaw size 8 mm)
1 x Ballpoint pen
For the connection of an aerial installed in the
vehicle you may require :
1 x Aerial adapters (in accordance with the technical
data of the aerial)
For the connection of an amplifier you will
require:
2 x Cinch connection cables
(insulation and plug: white / red)
Installation
L
Removing the control panel from
L
the car radio
• Avoid hard contact with the display window
• Press the "Open" button
1
panel to reach the horizontal position.
• Push the control panel
and pull it forwards.
• Store the control panel in the plastic box (see
also the illustration in the section „Attaching
the Control Panel").
Installing the DIN assembly bracket
L
in the vehicle's instrument panel
• Remove all packing material from the device.
• Unscrew the safety transport screws
pletely from the metal housing
and carefully release the plastic frame
the front of the device
• Release the attachment points by slightly raising
the upper frame edge and pulling it carefully
towards the front.
• Push the two installation keys
metal housing du
sembly bracket iq
Ensure that the convex side faces outwards in
KH2391_Content_UK.indd 11
4 and allow the control
1 slightly to the left
gp com-
du (see Fig. E)
2
from
ct .
ir
between the
and the preassembled DIN as-
until they clearly lock in place.
each case. Store the installation keys
for future use.
• Remove the DIN assembly bracket
it flush in the DIN assembly cut-out of the vehi-
cle's instrument panel.
• Secure the DIN assembly bracket
removal. Bend approximately ten tin dog points
on both the upper and lower side of the DIN
assembly bracket
outside. Please ensure that the DIN assembly
iq
bracket is installed flush in the DIN assembly
cut-out.
• Attached the plastic frame
front of the device
Connecting to the loudspeakers
L
of the vehicle
Tip! Use an ISO plug.
• Guide the connection cables of the loudspeakers
9 . mounted in the vehicle carefully out of the front
of the DIN assembly bracket
• Establish the connection between the connection
cables of the ISO plug and the connection cables
of the loudspeakers fitted to the vehicle with
the help of biscuit connectors, ensuring that
the connections in the biscuit connectors do
not cause any short circuits and that the fixing
screws are firmly tightened.
• Connect the lead of the plug-in
for the rear right loudspeaker.
• Connect the lead of the plug-in
for the rear right loudspeaker.
• Connect the lead of the plug-in
for the front right loudspeaker.
• Connect the lead of the plug-in
for the front right loudspeaker.
• Connect the lead of the plug-in
for the front left loudspeaker.
• Connect the lead of the plug-in
for the front left loudspeaker.
• Connect the lead of the plug-in
for the rear left loudspeaker.
• Connect the lead of the plug-in
for the rear left loudspeaker.
Preparation / Installation
ir carefully
iq and place
iq against
iq from the inside towards the
2 completely to the
ct
.
iq .
em to the lead (+)
en to the lead (-)
eo
to the lead (+)
ep to the lead (-)
eq to the lead (+)
er
to the lead (-)
es
to the lead (+)
et to the lead (-)
GB/IE
05.09.2006 14:49:11 Uhr
11