Model And Serial Numbers - KitchenAid 5KSB555AAC Service Manual

Midline blender

Hide thumbs

Table Of Contents

Table of Contents

Hall Effect Sensor (Fig. 15)

The various speeds of the blender are maintained

under varying load conditions with a hall effect

sensor (20), located at the bottom of the motor (17).

To remove the hall effect sensor (20), use a flathead

screwdriver to open two tabs (21) that hold the hall

effect sensor (20) to the motor (17). Disconnect

connector (12) from the control board (9).

Figure 15

Final Inspection

Always test the unit for proper operation after you have

completed a service procedure.

WARNING

Electrical Shock Hazard

Plug into grounded outlet.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in

death, ﬁ re or electrical shock.

Always check the blender for the presence of soil

from earlier food preparation and clean it before

repackaging. The blender power base and lid can be

cleaned with a mild soap solution applied to a damp

cloth and wiped dry with a soft towel. The blender jar

can easily be cleaned by placing it in an automatic

dishwasher.

You can also fill the jar half full of warm water and add a

few drops of liquid dishwasher detergent. Cover the jar

and blend the mixture in the "STIR" position for 10 - 20

seconds. Shut the blender off and unplug the unit from

the AC outlet. Rinse the blender jar with clean water

and dry with a clean towel.

BLENDER SERVICE MANUAL