Oven Control Functions; Setting Oven Controls; Select Self Cleaning - Kenmore 790.7851 Series Use & Care Manual

Oven Control Functions

READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become familiar with
the various pad functions of the oven as described below.
BROIL PAD— Used to
select the variable broil
function.
CLOCK SET
PAD— Used
to set the
time of day.
TIMER ON/OFF
PAD— Used to set
or cancel the minute
timer. The minute
timer does not start
or stop cooking.
Also,
TIMER ON/OFF pad
is used to set the
Continuous Bake
feature.
SELECT SELF-CLEAN
PAD— Used to select the
Self-Cleaning cycle. A 2,
3 or 4 hour Self-Clean
time may be selected.
*Note: The OVEN indicator light on the electronic display
will turn ON and OFF when using the Bake feature and
during preheat. This is normal and indicates that the oven
is cycling to maintain the selected baking temperature.
When the preheat indicator light turns OFF, your oven is
ready.
Temperature conversion
The electronic oven control is set to operate in °F
(Fahrenheit) when shipped from the factory. The oven can
be programmed for any temperature from 170°F to 550°F
(77°C to 287°C).

Setting Oven Controls

Note: The time of day must first be set in order to operate
the oven.
To Set the Clock
When the range is first plugged in, or when the power
supply to the range has been interrupted, the display will
flash "12:00".
1. Press once (do not hold pad down).
2. Within 5 seconds, press and hold the
the correct time of day appears in the display.
Note: The clock cannot be changed during a Self-Clean
cycle.
To Set the Minute Timer:
1. Press .
UP and DOWN ARROW PADS— Used along
with the function pads to select oven
temperature, time of day, clean time and
minute timer.
OVEN, PREHEAT & DOOR LOCKED LIGHTS* — The "OVEN" light
will glow each time the oven turns on to maintain the set oven
temperature. The "PREHEAT" light will glow when the oven is first
set to operate, or if the desired temperature is reset higher than the
actual oven temperature. The "DOOR LOCKED" light will flash
when the oven door locks and unlocks or when using the Self-
Clean cycle or the oven door lockout is activated. The indicator light
will glow constantly after the door locks.
To change the temperature to °C (Celsius) or from °C to
°F (control should not be in a Bake or Clean mode):
1. Press
2. Press and hold the
3. Press and hold
4. Press the
5. Press any control pad to return to normal operating
2. Press the
or until
3. The display shows the timer countdown in minutes until
4. When the set time has run out, the timer will beep 3
9
. "— —" appears in the display.
until "HI" appears in the
display.
until °F or °C appears in the display.
or to change °F to °C or °C to °F.
mode.
to increase the time in one minute
increments. Press and hold the
time in 10 minute increments. The timer can be set for
any amount of time from 1 minute to 11 hours and 59
minutes.
Note: If the pad is pressed first, the timer will
advance to 11 hours and 59 minutes.
1 minute remains. Then the display will countdown in
seconds.
times and will continue to beep 3 times every 60
seconds until is pressed.
FEATURE INDICATOR
LIGHTS— These light to
show which feature is in
use.
BAKE PAD—Used to
select the bake function.
STOP/CLEAR PAD—
Used to clear any
function previously
entered except the time
of day and minute timer.
Press STOP/CLEAR to
stop cooking. Also the
STOP/CLEAR pad is
used to activate Oven
Lockout setting.
to increase the