Lanier Cyan Toner for 5711 / 5811 117-0310 Material Safety Data Sheet

Identity:
Cyan Toner for 5711 / 5811
Product ID: 117-0310
Synonyms
& Common Cyan Toner for
Names: Lanier 5711, 5811
Uses: Lanier 5711, 5811 Color Copier
Chemical
Formula: Mixture
Polyester resin
Pigment
3
*PEL as the product: 15mg/m (total dust), 5mg/m
3
*TLV as the product: 10mg/m (total dust), 5mg/m
HMIS Rating:
FLAMMABILITY = 1
REACTIVITY = 0
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any non-toxic dust.
Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): Not known.
Remove to fresh air if effects occur. Gargle with water.
Inhalation: Get medical attention if needed.
Skin Contact: Wash with soap and water.
Suitable extinguishing media: CO
Extinguishing media which may not be used for safety reasons: none
Flammability: Non-flammable solid The decomposition products are CO, CO
Special protective equipment for fire fighters: none
UEL: n/a LEL: n/a
Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix AAA Toner Vacuum or
3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal injury. Remove residue with soap and cold
water.
Miscellaneous: Keep product out of sewers and watercourses.
Personal protection: Avoid inhalation of dust.
Special Handling: Cleanse skin after contact before breaks or meals, and end of workday.
Special Storage: Store in a cool, dry place. Avoid direct sunlight. Keep out of reach of children. Keep from contact with oxidizing materials.
Do not handle in windy areas. Flying powder may enter eyes. Minimize inhalation of dust. Cleanse skin thoroughly after
Miscellaneous: contact, before breaks and meals, and at end of work periods.
Section 8: Exposure Control and Personal Protection Information:
Respiratory Protection: none required under normal use.
MATERIAL SAFETY DATA SHEET
Section 1: Chemical Product and Company Information
Section 2: Composition / Information on Ingredients
PERCENT
85 – 95 % by weight
1 – 5 % by weight
3
(respirable dust)
3
(respirable dust)
Section 3: Hazards Identification
HEALTH = 1
SPECIAL = none
Section 4: First Aid Measures
Section 5: Fire Fighting Measures
, dry chemical, foam or water.
2
Section 6: Accidental Release Measures
Section 7: Handling and Storage
Emergency Telephone: (800) 526-4371
MSDS No.
CP- 325
Issued: 9/2/99
Supersedes: None
Date: 9/2/99
Prepared by: Lanier QA/EH&S Department 770-493-2361
Approved by: Larry Choskey, Sr. Quality Assurance Engineer
European Contact: Lanier Worldwide, WSM Europe,
Walter Fricke,
Im Taubental D-41468 Neuss, Germany
+49-2131-387-177
CAS No. EXPOSURE LIMITS
N/a
N/a
In case of contact, immediately flush eyes with
Eye Contact: water for 15 minutes. Get medical attention if
needed.
Ingestion: Dilute stomach contents with several glasses of
water. Get medical attention if needed.
Unusual Fire and Explosion Hazards: Toner material, like most
organic material in powdered form, is capable of creating a dust
explosion.
,. Avoid inhalation of smoke.
2
Hand Protection: none required under normal use.
Lanier Worldwide, Inc.
2300 Parklake Dr., N. E.
Atlanta, GA 30345-2979
SOURCE
N/a N/a
N/a N/a