Craftsman 917.288622 Operator's Manual page 7

Keys
Connect
Key(s)
Slope Sheet
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed,
(1) 1/2" wrench Tire pressure gauge
(2) 7/16" wrenches Utility knife
Pliers
When right or left hand is mentioned in this
manual, it meanswhenyouareintheoperating
position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
• Remove all accessible loose parts and
parts cartons from carton.
• Cut along dotted lines on all four panels
of carton, Remove end panels and lay
side panels flat.
• Check for any additional loose parts or
cartons and remove.
BEFORE REMOVING TRACTOR
FROM SKID
For battery and battery cable installation
see "REPLACING BATTERY" in the
"Service and Adjustments" section inthis
manual.
J
bel
TO ADJUST SEAT
• Sit in seat,
• Lift up adjustment lever (A) and slide seat
until a comfortable position is reached
which allows you to press clutch!brake
pedal all the way down,
• Release lever to lock seat in position.
TO CHECK BATTERY
1. Lift hood to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum clone hour at 6-10 amps. (See
"BATTERY" in Maintenance section of this
manual for charging instructions).
7