Section 3: Know Theedger; Section 4: Operating T Heedger - Yard-Man 552 Operator's Manual

SECTION 3: KNOW THEEDGER
Control Bail
Blade Depth
Control Lever
(Transport Position Shown)
Rope / Recoil Starter
Curb Height
Adjustment Lever
(If Equipped)
Bevel Adjustment
Lever(If Equipped)
NOTE: Wheel and blade styles vary.
Yours may differ slightly.
Spindle Sheaves Bel
Figure 4
,_ WARNING: Be familiar with all controls
and their proper operation. Know how to
stop the machine and disengage them
quickly.
NOTE: Refer to the Engine Manual packed with your
edger for a detailed description of all engine-related
controls and components.
PullRope / Recoil Starter
The pull rope/recoil starter is used to start the engine.
Primer
The primer is used to pump gas into the carburetor and
aid in starting the engine. Use it to start a cold engine,
but do not use it to restart a warm engine after a short
shutdown.
NOTE: Refer to the Engine Manual packed with your
edger for a detailed description of all engine-related
controls and components.
BladeControl B ail
Located on the upper handle, the blade control bail
must be depressed against the upper handle in order to
operate the unit. Releasing the blade control stops the
engine and the edger blade. See Figure 4.
BladeDepthControl L ever
The blade depth control lever is located on the right
side of the upper handle. It is used to control the depth
of the cut. The further forward the blade depth control
lever is moved, the deeper into the soil the edger blade
will cut. See Figure 4.
BevelAdjustment L ever (if soequipped)
The bevel adjustment lever, if so equipped, is located
on the front, left portion of the edger, behind the edger
blade. It is used to vary the angle of the edger blade
between one of three positions for edging/trenching or
beveled edging. See Figure 4.
CurbHeightAdjustment L ever(if so
equipped)
The curb height adjustment lever, if so equipped, is
found on the rear portion of the edger.When placed in
an applicable notch, it aids in stabilizing the edger while
edging grass along a curb. See Figure 4.
IMPORTANT: Become familiar with all the controls
before operating the edger.
SECTION 4: OPERATING T HEEDGER
The operation of any edger can result
in foreign objects being thrown into
the eyes, which can result in severe
eye damage. Always wear safety
glasses or eye shields. We
recommend wide vision safety mask
for over spectacles or standard
safety glasses
,_ WARNING: Do not lower blade if blade is
over concrete, asphalt, rocks or the like. The
blade can strike the supporting surface,
resulting in personal injury or property
damage.
Adding Gasoline AndOil
Service the engine with gasoline and oil as instructed in
the Engine Manual packed with your edger. Read
instructions carefully.
6