How To Adjust The Gauge Wheels - YARD KING Performance 50565x89 Instruction Book

MAINTENANCE
HOW TO ADJUST THE GAUGE WHEELS
The axle bolts for the gauge wheels were mounted in the LOW cut
position.To change the position of the gauge wheels, move the axle
bolts as follows.
IMPORTANT: Before you adjust the gauge wheels, you must do
• the following. Make sure the mower housing ts level. Make sure
the height of cut Is set at the height you want for your lawn.
Mow a short distance on a fiat level area and look st the area
that was cut. If the mower housing does not cut level, see the
instructions "How To Level The Mower Housing."
A WARNING: Before you make an Inspection, adjust-
ment, or repair to the unit, disconnect the wire to the
spark plug. Remove the spark plug wire to prevent
the engine from starting by accident.
t. Remove the gauge wheels (Figure 24).
2. Mow a short distance on a fiat level area to check the level of
cut and the height of cut. Look at the height of cut position
number on the lift lever (Figure 25),
3.
Look at each gauge wheel bracket. There are 3 holes in each
bracket and a number next to each hole. The number for the
height of cut position on the lift lever indicates the correct hole
to use on each gauge wheel bracket (Figure 26).
Wheel
Figure24
UftLever
Cutting Height Positions
4. Assemble the axle bolts to the gauge wheel brackets using
the correct hole in the bracket as indicated (Figure 26).
NOTE: If the height of cut position Is changed by the lift lever,
you must move the gauge wheels to the correct hole
(Figure 26) to keep a level height of cut.
Wheel Bracket Lift Lever
Hole No. Position No,
1 1
2 2
3 3,4,5,6
Figure26
712008 25