How To Use The Speed Control Pedal; How To Disconnect The Transmission; How To Drive Forward/In Reverse; Speed Control Pedal Positions - YARD KING 42566x89 Instruction Book

OPERATION
HOW TO USE THE SPEED CONTROL PEDAL
The drive system uses a Hydrostatic Automatic Drive transmission.
The Hydrostatic transmission is very easy to operate. This type of
drive system does not require a shift lever or a clutch pedal.
The speed and direction of travel is controlled by a singte speed
control pedal operated with your rightfoot. Do not use the teftbrake
pedal in normal operation. Only use the left brake pedal to quickly
stop in an emergency.
HOW TO DRIVE FORWARD
1. The automatic drive disconnect must be in the DRIVE
position (Figure 8).
2. Slowly release your left foot from the brake pedal
3. Move the throttle control to the FAST position.
4. Slowly push the speed control pedal forward to the desired
speed (Figure 7).
5. To increase forward speed, slowly move the speed control
pedal forward. To reduce forward speed, slowly release the
speed control pedal until the unit slows to the desired speed
Figure 7
HOW TO DRIVE IN REVERSE
1. Look to the rear.
2. Slowly push the speed control pedal to the REVERSE
position.
HOW TO CHANGE DIRECTIONS
CAUTION: To change directions, do not use the left brake
pedal. Use only the speed control pedal.
1 Slowly remove your foot from the speed control pedal. The
speed control pedal w!tlautomatically return to the NEUTRAL
position.
2. When the unit stops, slowly move the speed control pedal to
the desired direction.
SPEED CONTROL PEDAL POSITIONS
The forward speed iscontrolled by the position of the speed control
pedal The following chart provides functions along with the pedal
positions Always operate the engine with the throttle control in
the FAST position
FUNCTION
Trimming
Snow Thrower
PEDAL
POSITION
1/3
1/3 to 1/2
1/2 to 2/3
Bagging Grass
Normal Mowing
Easy Mowing 1/2 to 3/4
Snow Blade
Transport FULL
1/3 to 1/2
Pull Behind
Attachments
THROTTLE
FAST
FAST
lib
D
m
SLOW _
THROTTLE
HOW TO DISCONNECT THE TRANSMISSION
To push the unit, use the automatic drive disconnect to release
the transmission The automatic drive disconnect is under the
seat.
1. The engine must be off.
2. Raise the seat. The automatic drive disconnect is under Ihe
seat.
3. Move and latch the automatic drive disconnect in the PUSH
position (Figure 8). The transmission is now released and the
unit can be pushed.
NOTE: In cold weather, the heavy viscosity oil in the
transmission will make the unit difficult to push.
4 To engage the transmission, unlatch the automatic drive dis-
connect The transmission is now conl_ected and
re_dy
tO op-
erate
710846 14
sea,
A ut °rp_uats H Dr t(_; ITDli_)CN °nnec` _'_ -_--_--/_ F,gure 8