Safety Instructions, which are available as a separate document (9922 141 7014x). These instructions are supplied together with all equipment that can be connected to the mains. Thank you for choosing a Bosch Security Systems product! Bosch Security Systems | 2008-01 | PLE-2CS en...
Adjust the call station output volume ..........................13 6. Technical data ................................15 Electrical ....................................15 Performance ..................................15 Interconnection ..................................15 Mechanical ..................................... 15 Environmental conditions ..............................15 Certifications and Approvals ............................. 15 Bosch Security Systems | 2008-01 | PLE-2CS en...
Page 4
Plena Two-zone Call Station | Installation and User Instructions | Table of contents en | 4 Intentionally left blank Bosch Security Systems | 2008-01 | PLE-2CS en...
Persons can be (severely) injured, or the equipment Icon for risk of electrostatic discharge. can be seriously damaged, if the alert is not observed. • Danger Not observing the alert can result in death. Bosch Security Systems | 2008-01 | PLE-2CS en...
To this end, the call station is equipped with seven with the PLE-series two-zone mixer and mixer built-in chimes. amplifiers. In addition to tabletop use, the Plena design allows neat flush-mounting in desktops. Bosch Security Systems | 2008-01 | PLE-2CS en...
3 Rotary volume control - A rotary volume control (potentiometer) to set the output volume of the call station. See chapter 5.3. Plena figure 2. 1 : Top view figure 2.2: Bottom view Bosch Security Systems | 2008-01 | PLE-2CS en...
RJ-45 sockets can be used. figure 3. 1 : Connecting the call station to the mixer or the mixer amplifier Make configuration settings 1 Make the configuration settings (see section 4.2). Bosch Security Systems | 2008-01 | PLE-2CS en...
Page 10
Plena Two-zone Call Station | Installation and User Instructions | Installation en | 10 Intentionally left blank Bosch Security Systems | 2008-01 | PLE-2CS en...
1 = latching, 0 = momentary. 4.2.3 Speech filter setting See figure 4.2. DIP switch number 5 is used for setting the speech filter ON (1) of OFF (0). figure 4. 1 : Connecting multiple call stations Bosch Security Systems | 2008-01 | PLE-2CS en...
See figure 5.1. Caution Be careful not to damage the printed circuit board located directly underneath the orifice. Use a small screw driver, preferably a plastic one. Bosch Security Systems | 2008-01 | PLE-2CS en...
Page 14
Plena Two-zone Call Station | Installation and User Instructions | Operation en | 14 Intentionally left blank Bosch Security Systems | 2008-01 | PLE-2CS en...
EMC emission: Speech filter: According to EN 55103-1 - 3 dB @ 315 Hz, high-pass, 6 dB/oct Output impedance: 200 Ω Interconnection Type: 2x redundant RJ-45 sockets for daisy chaining multiple call stations. Bosch Security Systems | 2008-01 | PLE-2CS en...
Page 16
Plena Two-zone Call Station | Installation and User Instructions | Technical data en | 16 Intentionally left blank Bosch Security Systems | 2008-01 | PLE-2CS en...