Agitator Servicing - Kenmore 116.21514 Use & Care Manual

I
LIGHT BULB CHANGING
_kWARNING
Electrical Shock Or Personal Injury
Hazard
!Turn off and unplug vacuum cleaner
before performing maintenance to the
vacuum cleaner. Failure to do so could
result in electrical shock or personal
injury from the vacuum cleaner
suddenly starling.
NOTE: Use replacement bulb number 20-
52,48, see part number detail in REPLACE-
MENT PARTS(page 6).
I. Remove PowerMate cover as shown in
BELT CHANGING AND AGITATOR
CLEANING (page 23-24) section.
2. Remove the light
bulb by pulling
straight out.
,,11 i
la,cAuT,oN
IDa not plug in or turn on until the vacuum
Icleaner is completely reassembled.
JDo not use a bulb rated over 9W
J(13V). During extended use, heat from
Jthe bulb could overheat surrounding
Plastic parts.
_ _ _. t I 3. To replace the
eusnm I light bulb, core-
rO rlgn_
/-_ -_,,,,_ _ fully insert fully
_ 4. Reinstall
PowerMate cover
as shown in BELT CHANGING AND
AGITATOR CLEANING (page 23-24)
section.
AGITATOR SERVICING
,_ WARNING
Electrlcal Shock Or Personal Injury
Hazard
Always turn off and unplug vacuum
cleaner before performing maintenance
to the vacuum cleaner. Failure to do so
could result in electrical shock or personal
injury from vacuum cleaner suddenly
s!art!ng. , .........
New Brushes Worn Brushes
Base
Supped
Bet
TO CHECK THE BRUSHES
When brushes are worn to the level of the
base support bars, replace the agitator
assembly,
TO REPLACEAGITATOR
ASSEMBLY
1. Remove PowerMate cover, belt and
agitator assembly. See "To Remove Belt" in
BELT CHANGING AND AGITATOR
CLEANING (page 23-24).
2, Replace agitator assembly. See your
separate repair parts list for part number.
3. Reinstall belt and PowerMate cover. See
"To replace belt" in BELT CHANGING AND
AGITATOR CLEANING (page 23-24}.
25
{