Washing
Procedures
(continued)
Safety
Lid
Lock
.
Start the
washer.
Close the washer lid and pull out the cycle selector knob Washer will fill and
agitate with the lid open The tub will not spin unless the lid is closed
•
To stop the washer, push in the cycle selector knob
•
Do not stop and restart washer during a spin when using the fabric softener
dispenser
•
To change a cycle, push in the cycle selector knob Turn it clockwise to the
desired setting Pull out the knob to restart the washer
10.
Remove items when the cycle is completed.
Foryour safety, the lid locks when the tub is spinning It will remain locked for
about 1 minute after the tub stops spinning
•
To open the lid during a spin, push in the cycle selector knob and wait about
1 minute for the lid lock to release Do not force open the locked lid
Placewashed items in automatic dryer, line dry, or dry flat as directed by fabric
care label, Excesswrinkling, color transfer or odors may develop in items left
in the washer after the cycle has ended,
To avoid serious personal injury, do not operate washer if safety lid
lock is missing or damaged,
Stain
Removal
Do not combine stain removal products.
Safe Stain
Removal
Procedures
To reduce the risk of fire or serious injury to persons or property,
comply with the basic warnings listed below:
•
Read and comply with all instructions
on stain removal products
•
Keep products in their original labeled containers
and out of children's
reach
•
Thoroughly wash any utensil used
•
Do not combine stain removal products, especially ammonia and chlorine
bleach
Dangerous fumes may result
•
Never wash items which have been previously cleaned in, washed in,
soaked in or spotted with gasoline, dry cleaning solvents or other flammable
or explosive substances because they give off vapors that could ignite or
explode
•
Never use highly flammable solvents, such as gasoline, inside the home
Vapors can explode on contact with flames or sparks
Follow fabric care label instructions
For successful
stain removal:
•
Remove stains promptly
•
Determine the kind of stain, then follow recommended
treatment
in the
stain removal chart on the next page
•
To pretreat stains, use a prewash product,
liquid detergent,
or a paste
made from granular detergent
and water
•
Use cold water on unknown stains because hot water can set stains
•
Check care label instructions
for treatments
to avoid on specific fabrics
•
Check for colorfastness by testing stain remover on an inside seam
•
Rinse and wash items after stain removal