Kenmore 50 Instructions Manual page 5

@
@
INSTALLING MACHINE HEAD IN PORTABLE
AND CABINET
Loosen the two hinge screws under holes in the rear
edge of the machine bed (1). Raise hinge pins in
the cutout (2). Slip machine head onto the pins and
tighten hinge screws securely (3).
Lower machine head to front flap.
Lay the plastic discs over the spool pin hole on the
arm cover plate. Screw pins in place. Discs and
pins are packed in accessory box.
When head is in place for sewing, there will be a
small open space between the edge of the sewing
head and the cabinet. This space is reserved for the
convenient plastic accessory tray which fits therein.
SEWING LIGHT
The sewing light is placed inside the face cover
plate as shown. It may be turned on or off by
pushing light switch. To change bulb, open the face
cover plate by swinging it open, twist old bulb away
from you and remove. Then insert new bulb.
CONNECTING MACHINE
Push the plug onto three prong connector over the
machine motor.
Plug machine cord into any 110-120V wall outlet.