Advertisement
Available languages
Available languages
installation
STEP 4
CONNECT ELECTRICAL
. Plug power cord into properly
grounded
receptacle.
* Press the button on the left side of the control
panel. The lights above the knobs should
illuminate.
STEP5
CHECK BURNERS
Check to be sure that burner heads and cops
ore securely seated.
Burner CapProperly Seated
Burner CapNot Properly Seated
.Check for proper ignition:
- Push in one control knob and turn to LITE
position.
- The igniter will spark and the burner will light;
the igniter will cease sparking when the burner
is lit.
- First test mug require some time, while air
is flushed out of the gas line.
- Turn knob to OFF.
- Repeat the procedure
for each burner.
IMPORTANT: If the igniter electrodes
continue
to spark after the burners ore lit, check that
each burner component
is assembled
properly.
Refer to the Owner's Manual.
.Burner
flames should be blue and stable with no
yellow tips, excessive noise or lifting of the flame
from the burner. If any of these conditions
exist,
check that the burner ports ore not blocked.
If one of these conditions
continues,
cull for
service.
FINALIZE INSTALLATION
Place the burner grates over the burners.
The grates should be seated and should not rock.
The griddle is secured with screws. It is designed
to be stationary
and should not be removed.
The griddle has two leveling screws beneath
the rear flue cover that con be used to adjust
to the desired slope.
GriddleFlueCover
Clamping Screws
The two inner screws ore clamping
screws for
securing the griddle in place. Loosen these two
screws before leveling. Do not remove these two
screws.
The two outer screws ore leveling screws. Do not
remove these two screws. They con be turned to
level the griddle or to provide o forward
slope to
help grease and oils to drain away from the food
being cooked.
After leveling the griddle, hand-tighten
the clamping
screws; do not over-tighten.
ll
INSTALLATION
CHECKLIST
0 Make sure oil controls ore left in the OFF
position.
0 Make sure the flow of combustion
and
ventilation
air to the rongetop
is unobstructed.
0 The serial plate for your rongetop
is located
on the bottom of the rongetop.
In addition
to the model and serial numbers,
it tells you
the ratings of the burners and the type of fuel
and pressure the rongetop
was adjusted
for when it left the factory.
0 Recheck Steps:
Double check to make sure evergthing
in this manual has been completed. Rechecking
steps will ensure safe use of the rangetop.
Advertisement
