Echo CHAIN SAW CS-330T Instruction Manual page 23

CS-330T
The accepted way to hold the saw is to stand to the left of the
saw with your left hand on the front handlebar and your right
hand on the rear handle so you can operate the throttle trigger
with your right index finger. Before attempting to fell a tree, cut
some small logs or limbs. Become thoroughly familiar with the
controls and the responses of the saw.
Start the engine, see that it is running properly. Squeeze the
trigger to open the throttle wide open and start the cut. If the
chain is properly sharpened, the cutting should be relatively
effortless. It is not necessary to press down hard to make the
saw cut. Pushing the saw too hard will slow the engine and
cutting will actually be more difficult.
Note: Some material may adversely affect the housings of your
ECHO chain saw.(Example: Palm Tree Acid, fertilizer,
etc.) To avoid housing deterioration, carefully remove all
packed saw dust around clutch and guide bar area and
wash with water. Coat metal parts with light oil.
Felling the Tree
A falling tree can seriously damage anything it may hit - a
car, a house, a fence, a power line, or another tree. There
are ways to make a tree fall where you want it, so first
decide where that is!
Before cutting, clear the area around the tree. You will need
good footing while working and you should be able to work the
saw without hitting any obstacles. Next, select a path of retreat.
When the tree begins to fall you should retreat away from the
direction of fall at a 45-degree angle and at least 3 m (10 feet)
from the trunk to avoid the trunk kicking back over the stump.
X7503245101
© 08/2013 ECHO Inc.
For more information on
scan this QR code.
3 m (10 feet)
Direction of fall
45°
Retreat
OPERATION
Retreat
45°
Not this way
23