Burner Ignition - GE JGP626AEV1AA Installation Instructions Manual

STEP 6: ASSEMBLING THE COOKTOP BURNERS
Place the burner head on the burner bowl. so that
the location of the spark igniter matches up with the
opening in the burner head. Position the burner cap
on the burner head. Place the burner grate over the
burner assembly and into the burner bowl. The
bottoms of the burner grates have fingers that fit into
the corresponding indentations in the burner bowl.
BURNER GRATE
BURNER _ _ SPARK IGNITER
_ MIXER TUBE (CHIMNEY)
]'urn each burner full on. Flames should be blue in
color with no irace of yellow. Foreign particles in the
gas line may cause an orange flame at first but this
will soon disappear,
The burner" flames should not flutter or blow away
from the burner, Tile inner cone of the ilame should
be between 1/2" and 3/4" long.
COOKTOP
BURNER
STEP 7: CHECK THE IGNITERS
Operation of electric igniters should be checked after
cooktop and supply line connectors have been
carefully checked for leaks and cooktop has been
connected to electric power.
To check for proper lighting, push in and turn a
burner valve to the LITE position. The burner valve
should light when gas is available to burner. Once
the burner lights, it should be turned out of the LITE
position. Try each valve separately until all burners
have been checked out.
BURNER IGNITION
COOKTOP SPARK IGNITION -- When you turn the
cooktop Mmb to LITE. the spark igniter makes a
series of electric sparks {ticking sounds) which light
the burner,
During a power failure the burners will not light
automatically. In an emergency, a cooktop burner
may be lit with a match by following the steps below,
1. Ligtlt a malch and hold the flame near the burner
you want to light. Wooden matches work best.
2. Push m and turn the control knob slowly. Be
sure you are turning the correct knob for the burner
you are lighting.
NOTE: If the burner does not light within five
seconds, turn the knob off and wait one minute
before trying again.
STEP 8: WHEN ALL HOOKUPS ARE
COMPLETED
MAKE SURE ALL CONTROLS ARE LEFT IN THE OFF
POSITION.
MAKE SURE THE FLOW OF COMBUSTION AND
VENTILATION AIR TO THE RANGE IS UNOBSTRUCTED.
MODEL AND SERIAL NUMBER LOCATION.
The serial plale for your eooktop is located on the
bottom of tile burner box. In addition to the model
and serial numbers, it tells you the ratings of the
burners and type of fuel and pressure the cooktop
was adjusted for when it left the factory.
When ordering parts, always include the serial
nulnbcr, model number and code letter to ensure
proper replacement paris. Parts may be obtained
thl-ougil General Eleciric/Hotpoint Factory Sen'ice
Centers or General Electric/Hotpoint authorized
Cl.lSlOlllel* CaI-c
servicers.