Dell Latitude C500 Series Service Manual page 21

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Manual
a. Use a scribe to lift the right edge of the center control cover and pry it loose from the bottom case assembly.
b. Lift the center control cover up and away from the bottom case assembly.
3. Close the display.
4. From the back of the computer, remove the five M2.5 x 5-mm screws labeled with the "circle D." There are two screws
on the right hinge and three screws on the left hinge.
5. Open the display assembly approximately 180 degrees and support the display assembly so it does not open past this
position.
6. Remove the two M2 x 3-mm screws that secure the EMI shield bracket to the system board assembly.
7. Remove the flex cable EMI shield retention bracket that covers the display-feed flex cable connector on the system
board.
8. Pull straight up on the display-feed flex cable connector to disconnect the connector from the system board (see
"Display Assembly").
9. Lift the display assembly from the bottom case assembly.
NOTICE: When reconnecting the display-feed flex cable connector to the system board, push down on the top left
and right ends of the connector (see
the connector may damage resistors and compromise EMI protection in the system.
Reconnecting the Display-Feed Flex Cable Connector
14.1-Inch Display Assembly Bezel and Panel
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/L...600/C500%20C600%20Service%20Manual/remove.htm (12 of 36)6/21/2004 1:22:14 AM
"Reconnecting the Display-Feed Flex Cable Connector"). Pressing on the center of