Assembling The Port Replicator - Fujitsu Connectivity Peripherals Point 1600 Installation Manual

Assembling the Port Replicator

The port replicator is assembled using a cradle module and a portable port expander. The process of
assembling the port replicator is outlined in the following:
• Install the portable port expander in the cradle module.
• Attach the rubber feet to the cradle module.
• Attach the wire catch to the cradle module.
(Required if using the port replicator with the folding desk stand.)
Detailed procedures for these tasks are given in this section. Before you begin, the latch and spacer
provided with the portable port expander must be removed. See "Removing the Latch and Spacer (For
Installation in Cradle Module Only)" on page 2-1 for details.
Note that the following hardware is included with the cradle module and is used when assembling the
port replicator:
• Four rubber feet with four mounting screws
• Wire catch
• Cover label (not used in this assembly)
• Two tube keys for use with the tubular lock (locking versions only)
Assembling the Port Replicator
2
2-3