Kenmore 790.4637 Use & Care Manual page 35

Genera Care & C eaning
Specia_ Door Care mnstructions
Most oven doors contain glass that can break.
Read the following recommendations:
1. Do not dose the oven door until all the oven racks are fully in place.
2. Do not hit the glass with pots, pans, or any other object.
3. Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.
Removing and Replacing the E×terna_ Door G_ass Panem
Applicable only to models with an external glass panel not held with frame. This design allows you to clean the inside
face of the exterior door panel as well as the hidden face of the door inner glass.
To Remove the ExternaJ Door Glass Panel:
1. Remove the door as described in Removing and Replacing the Oven Door section and lay the door fiat.
2. Using a screwdriver, remove the 5 screws fastening the glass & molding assembly.
3. Grasp both sides of the glass panel and slowly pull it out of the door upper molding. Lay the glass fiat.
To Reptace the ExternaJ Door Glass Panel:
1. Grasp the sides of the glass panel carefully insert the glass into the door top molding.
2. Replace the 5 locking screws.
3. Replace the door onto the range.
Handle the glass panel with care. When dropped on a corner, the glass panel may shatter. This can cause
severe personal injury.
...... -, Removing and Replacing Warmer (Warm & Ready TM) Drawer
Left Gmide Pull up iatch
with finger
Push down match Right Glide
with finger
Figure 1
Figure 2
To Remove Warmer Drawer:
1, _ Turn power off before removing the warmer drawer,
2, Open the drawer to the fully opened position,
3, Locate glide lever on each side of drawer, pull up on the left glide lever
and push down on the right glide lever (See Figure 1),
5, Pull the drawer away from the range,
To Replace Warmer (Warm & Ready
TM)
Drawer:
1. Pull the bearing gJides to the front of the chassis glide (See Figure 2).
2. Align the glide on each side of the drawer with the glide slots on the
range.
3. Push the drawer into the range until levers "click" (approximately 2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the Jevers "click" or the bearing gtides do not feet seated
remove the drawer and repeat steps 1 thru 3. This will minimize
possible damage to the bearing glides.
NOTE: The Warmer Drawer will NOT operate while in the"Self-Clean" and "Oven
Lockout" modes
Electrical Shock Hazard can occur and result
in serious injury or death, Disconnect appliance from electric
power before cleaning and servicing the warmer drawer,
35