Remote-Starting Your Vehicle; Setting Your Vehicle Into Ready Mode - Autostart AS-2775 User Manual

- Once the activation countdown expires, the LED will send a series of quick double
flashes to indicate that the Starter Kill is now armed.
• To disarm the Starter Kill, press the
- The Starter Kill will automatically rearm itself after 1 minute (by default) or 3 minutes
(if configured this way) if no door is left opened (if the doors are monitored) and the
ignition is not turned
Active Mode:
• To arm the Starter Kill, press the
- The parking lights will flash once.
- The LED on the antenna will flash slowly.
- If remote door locks are installed, this will also lock the doors and arm the OEM-style
alarm.
• To disarm the Starter Kill, press the
- The parking lights will flash twice.
- The LED on the antenna will remain
- If remote door locks are installed, this will also unlock the doors.

Remote-Starting Your Vehicle

If your vehicle has an automatic transmission, simply press the
stop your vehicle. Skip the next steps on to "Remote-starting".

Setting Your Vehicle Into Ready Mode

If your vehicle has a manual transmission you must read the following indications. In order to
start the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on
the option that was selected by your installer. Therefore, you must follow the appropriate
procedure between the two described below in order to set your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the
position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2. With the engine already running, apply the
parking brake once and release the brake
pedal.
Make sure to release the brake pedal.
3. Within 20 sec. of engaging the parking
brake, press and hold
on the transmitter.
START
The parking lights will flash 3 times
quickly and remain lit.
4. Remove the key: the engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
P. 4
UNLOCK
.
ON
button on the transmitter.
LOCK
UNLOCK
OUT
, or
LOCK UNLOCK
button on the transmitter.
button on the transmitter.
.
START
If Ready Mode is enabled by handbrake
2. With the engine already running, apply the
parking brake twice and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
button to remote start or
IGNITION ON (RUN)
-
User Guide